Home Umbilical Management Systems Clamps

Products & Solutions

Stay Connected

Request a Quote

Email:
Subject:
Message:
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow

Clamp Inquiry Form

Clamp Inquiry Form

 

Clamps

  • Print

ABCO Subsea's clamp line can be used in a variety of applications from guide wires to production risers or drilling risers. Special designs can be attached to any type of structure. All of ABCO's clamps are modular creating a flexible system so that all our clamp shells will connect toall our mounting assemblies for simplicity and ease of use. ABCO can apply one of our existing clamps to your application or develop a new design for your custom needs.

SB-BOP Hose Clamp
SB-BOP Clamp Spec Sheet

The SB-BOP Clamp is designed for a single large umbilical, 2.5 to 6 inches OD (63.5 to 152.4 mm OD), to clamp to a 0.75 inch to 1.5 (19  to 38 mm OD) cable (Pod Recovery Line). This clamp is a polyurethane shell with a steel mounting assembly that provides a light weight design with a sleek exterior that has no sharp edges preventing fouling or entanglement with other equipment during operations
SB6.5Shim

 

 MUX Clamp
MUX Clamp Spec Sheet

The MUX Clamp product line is an all stainless steel clamp designed for multiple lines less than 3 inches (76 mm) in diameter ideally designed for MUX lines, small electrical or fiber-optic lines, and other types of monitoring cables. The MUX clamp attaches to the marine drilling riser, such that the supported cables are protected within the syntactic foam envelope. Clamps vary in height and are easily removed by the release pin.

HSDW6.5Shim

 

IWOCS Clamp
IIWOCS Clamp Spec Sheet

The SB-BOP Urethane Clamp is designed for use with Installation/Workover Control Systems (IWOCS). This clamp is light weight in design and has no sharp edges therefore preventing fouling or entanglement with other equipment during running operations.

SB-IWOC_Clamp-sm

 

 A/R Rotation Clamp Base
AR Rotating Clamp Spec Sheet

The A/R Wire Rope Clamp Base was developed to allow the clamp base & clamp/umbilical to remain relatively unaffected by the wire line rotation. This prevents umbilical or cable "wind" around the down line. This base can be used with any ABCO Clamps.

                                             RotatingClampAssy

 

Derrick Clamp
Derrick Clamp Spec Sheet

ABCO's Derrick Clamp is designed to prevent cable clashing of the top drive/compensator power and control lines on the derrick. The clamp grips the power cable while allowing the control cable to slide freely. ABCO's clamps are available in both single and double configurations.
DerrickClampAssem

 Custom Clamps
Clamp Inquiry Form

ABCO can also design special custom clamps if we do not have a clamp to fit your application. With a few parameters, our engineering department can design and build products specifically for your special offshore requirements.

    Dual_Clamp_Rendering-sm